Controls - Rear Panel; Installing The Monitor Driver - Honeywell HMLCD15 User Manual

2.2 CONTROLS – REAR PANEL
D
C
B
A
PC
A DC12V
B Ear
C PC Sound
D VGA
E Video Sound
F S-VHS
G Composite
Rev. A
E
F
G
DVR or VCR
AV1
6 HMMU000880
04/08/04
2.3

INSTALLING THE MONITOR DRIVER

You can achieve an optimal resolution and scanning rate by
installing the monitor driver as follows:
1. Insert the monitor driver diskette into the floppy diskette
drive and run INSTALL.EXE.
2. Select the monitor model then press OK.
The installation will begin immediately.
2.4 VGA CABLE
A 15-pin D-Sub connector is used as the input signal connector.
Pin and input signal are shown in the table below.
Pin Name Pin Name
1 Red 2 Green
4 N.C 5 GND
7 GREEN-GND 8 BLUE-GND
10 Logic-GND 11 N.C
13 H-sync 14 V-sync
Rev. A
Pin Name
3 Blue
6 RED-GND
9 +5V
12 SDA (DDC)
15 SCL (DDC)
7 HMMU000880
04/08/04