Operating Instructions; How To Clear Obstructed Food - Nesco FG-300 Care/Use Manual

1. Place the unit on a flat and stable work surface. Be sure unit is fully
assembled (see Assembly Instructions, page 3).
2. Make sure the Switch is in the "OFF" (O) position.
3. Insert plug into standard 120 Volt electrical outlet, rated 15A minimum.
4. Place a wide bowl or plate beneath the Grinder Head to catch ground food.
5. Press Switch to "ON" (I). Always have the unit running before adding food.
6. Cut food into strips or cubes slightly smaller than the Food Hopper opening.
7. Place food into the Food Hopper and use Pushrod to gently feed food into
the Grinder Head. Do not force food into the Grinder Head and NEVER
use fingers or other tools, other than those recommended by appliance
manufacturer, to feed food into Grinder Head.
8. If the motor slows or stops, this may be due to jammed food. See instructions
below for clearing jammed foods. IMPORTANT - NEVER PUT YOUR
FINGERS INTO THE FOOD HOPPER OPENING WHILE UNIT IS
OPERATING OR PLUGGED INTO ELECTRICAL OUTLET.
9. When you have finished grinding food, press Switch to "OFF" (O), unplug
from electrical outlet and follow cleaning instructions.
1. If the motor slows or stops, press Switch "OFF" (O) immediately.
2. Press ON/OFF switch to "II" position, then press REV switch for several
seconds to clear the obstruction.
3. Release the Reverse switch and move ON/OFF to "I" position. Try operating
as normal.
4. If motor slows or stops again, press Switch "OFF" (O) and unplug from electrical
outlet. Follow cleaning instructions.

OPERATING INSTRUCTIONS

How to clear obstructed foods
5
On/Off
Switch
Reverse
Switch