Advertisement
FCC
The modem was tested and certified to meet FCC Parts 15 in a stand-alone configuration, which demonstrated that the GSM2000 Mini-MT
complies with Part 15 emission limits. FCC Part 22 & Part 24 is covered by the Enfora Enabler-IIG "modular approval" process for a transmitter.
This approach, described by FCC Public Notice DA 00-131407 released June 26, 2000, is intended to afford relief to equipment manufacturers by
eliminating the requirement for obtaining a new equipment authorization for the same transmitter when installed in a new device.
In order to use the GSM2000 MINIMT without additional FCC certification approvals, the installation must meet the following conditions:
For the transmitter to meet the MPE categorical exclusion requirements of 2.1091, the ERP must be less than 1.5 watts for personnel
separation distance of at least 20 cm (7.9 in). Therefore, the maximum antenna gain cannot exceed +3.3dBi. If greater than 1.5 watts exists,
then additional testing and FCC approval is required.
R&TTE -
The GSM2428 Mini-MT modem has been fully tested and complies with all the requirements of EN301 489-1, EN301 489-7 and EN60950-
1:2001. Compliance to EN301 511 has been demonstrated by testing on both the GSM2000 and the integrated GSM0108 module.
Disclaimer
The information and instructions contained within this publication comply with all FCC, GCF, PTCRB, R&TTE, IMEI and other applicable codes
that are in effect at the time of publication. Enfora disclaims all responsibility for any act or omissions, or for breach of law, code or regulation,
including local or state codes, performed by a third party.
Enfora strongly recommends that all installations, hookups, transmissions, etc., be performed by persons who are experienced in the fields of
radio frequency technologies. Enfora acknowledges that the installation, setup and transmission guidelines contained within this publication
are guidelines, and that each installation may have variables outside of the guidelines contained herein. Said variables must be taken into
consideration when installing or using the product, and Enfora shall not be responsible for installations or transmissions that fall outside of the
parameters set forth in this publication.
Enfora shall not be liable for consequential or incidental damages, injury to any person or property, anticipated or lost profits, loss of time, or
other losses incurred by Customer or any third party in connection with the installation of the Products or Customer's failure to comply with the
information and instructions contained herein.
Regulatory Compliance
Page
13
Enfora Mini MT User Manual
13
Advertisement
