Advertisement
Change status is in
red.
Only last change
is recorded here
RECEPTION:
For inspecting device signal quality, device receiver
working condition, and battery level change history.
Captured: Device is put in a good place/position with
good signal quality - location is successfully captured
from satellite. Address and map is successfully
updated on map at the time.
Seeking: Device is not with good placement/position,
satellite signal can not be received or signal quality is
bad – device has tried receive from satellite but
ended with failure. Usually caused by improper
physical placement, position or angel, being inside a
building, facing against metal, battery body, magnet,
or other objects that blocks radio signal, or inside
metal enclosure. The way location or address can not
work out.
Select new interval to send over to device. Confirmation by
device is totally depends on the current status of device:
Awake (device is in motion): Change delivered will be
accepted by device immediately, and confirmation will be
sent back (shown in red).
Sleeping (stationary over 1 minute, which will
automatically shut power off), or physically powered off:
Change will be pending in air and will be accepted by device
the next time when device wakes up or powered back on.
Change is ONLY deliverable within 24-48 hours – it may be
discarded if pending in air over24-48 hours.
Page
19
Enfora Mini MT User Manual
Click on this button to
open set interval
window (as shown
from left of this screen)
Device information last
received from it, with date
time stamp of receiving
time.
Aging time shown here is
calculated since last Captured
signal (refer to explain from right
side).
19
Advertisement
