Table of Contents
Advertisement
purchaser specific legal rights and the purchaser may have other legal rights that vary from jurisdiction to
jurisdiction. This limited warranty shall be governed by the laws of the State of Texas, United States of
America, without regard to conflict of laws principles. This limited warranty shall not be governed in any
respect by the United Nations Convention on Contracts for the International Sale of Goods.
Regulatory Compliance
FCC
FCC ID: MIVGSM2428; MODEL NUMBER: GSM2428
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits pursuant to Part 15 Subpart B, Part
22, and Part 24 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in an appropriate installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not used in accordance with instructions, can cause harmful radiation to radio
communication. However, there is no guarantee that interference will not occur in a particular installation.
RF EXPOSURE
Your device is a radio transmitter and receiver. It is designed and manufactured not to exceed the
emissions limits for exposure to radio frequency (RF) energy set by the Federal Communications
Commission (FCC) of the U.S. Government. These limits are part of comprehensive guidelines and establish
permitted levels of RF energy for the general population. These guidelines are based on the safety
standards previously set by the U.S. and international standards bodies. The standards include a
substantial safety margin designed to assure the safety of all persons, regardless of age and health.
The exposure standard for wireless RF devices, such as the device, employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. SAR values at or below
that limit are considered safe for the general public.
Before a wireless RF device is made available for sale to the Public, it must be tested and certified to the
FCC that it does not exceed the SAR limits established by the FCC. Tests for SAR are conducted using the
positions and locations (e.g., at the ear or worn on the body) as required by the FCC for each device model.
The device has been tested and meets the FCC RF exposure guidelines when used against the body using
the supplied belt clip under normal usage conditions. This device conforms with the RF exposure
requirements for portable devices in accordance with FCC Part 2.1093. This equipment complies with FCC
RF radiation exposure limits set forth for an uncontrolled environment for portable devices.
Use of non-approved accessories may violate FCC RF exposure guidelines
- IV -
Advertisement
Table of Contents
