Installation Instructions For The Puretouch Aquasuite - Moen PureTouch AquaSuite 77100 Owner's Manual

PRE-INSTALLATION TIPS
Recommended tools:
Safety glasses, flash light, drill
w/ 1" circular hole saw, punch
(optional), phillips screw
driver, thread seal tape, 8"
Kitchen
adjustable wrenches (2), pliers,
tape measure.
Determining the location
for install
The PureTouch ® AquaSuite can
be installed near a kitchen or
hole cutout options
bathroom sink. The AquaSuite
faucet may be installed either
to the left or right of your
current faucet. When you install
the AquaSuite you will have the
choice of orienting the handle
direction for easy operation on
Bathroom
the left or right side of your
kitchen or bath faucet.
Decide which spout you will
install (low profile or high profile
– see page 4 for picture) and
ensure that spout will extend far
enough into the sink for your
filtration needs. If installing the
low profile spout, the
recommended distance from
edge of sink to center of
installation hole is 4-1/4" to
4-3/4". If installing the high
profile spout, the recommended distance from edge of sink to center of
installation hole is 3-1/2" to 4".
The AquaSuite faucet can easily fit into a pre-existing hole such as those used
for a soap dispenser or kitchen faucet side spray. If a hole is not already
available, you'll need to cut out a 1" diameter hole in the location on the sink or
countertop where you wish to install the faucet, making sure that the location is
a flat surface with minimal obstruction. A 1" diameter hole is recommended but
can be as large as 1-5/8" diameter.
5 HELPLINE: 1-877-DRINK-H2O INS412A
(1-877-374-6542)