How To Create An Insteon Scene; Creating An Insteon Scene; Advanced Features Of Motion Sensor; Adjusting Aim And Sensitivity Of Motion Sensor - SMART INSTEON Owner's Manual

HOW TO CREATE AN INSTEON SCENE

Creating an INSTEON Scene

INSTEON scenes let you activate dramatic lighting moods with the press of just one button. For example, you
can set all your lights in a scene to dim to 50%, or turn certain lights on while turning others off, all with the tap
of a button on a Controller.
INSTEON scenes are very easy to set up – just Link more than one INSTEON Responder to the same On/Off or
Scene button on an INSTEON Controller. Then, when you press any of the Linked buttons on the Controller, all of
the INSTEON devices Linked in the scene will respond as a group.
To set up an INSTEON scene, you can individually Link each device to your Controller (see your device's Owner's
Manual for instructions on how to Link the device to a Controller). Or, save time and create multiple Links.

ADVANCED FEATURES OF MOTION SENSOR

Adjusting Aim and Sensitivity of Motion Sensor

1) Tap the Set button on Motion Sensor until the Responders turn off
2) Within 10 seconds, walk well out of the detection area
3) Wait 20 seconds
4) Walk into and near your detection area
The red Motion Sensor LED should flash upon initial motion, and then once every 8 seconds during motion
•
If the LED does not flash while you are moving within the desired detection area, re-aim the
Sensor (usually by pointing Motion Sensor up)
•
If the LED flashes while you are moving outside the desired detection area, try:
i. Aiming Motion Sensor to decrease the range (usually by pointing Motion Sensor
ii. Placing Jumper 1 on both pins. See Setting the Jumpers.
Motion Sensor Owner's Manual
down)
Page 7 of 13