Table of Contents
Advertisement
4.3.7 Sensor Setup (continued)
SETUP
http://192.168.1.200
#
0
1
2
3
4
5
6
7
#: Sensor ID/address configured on the Connector/Transmitter. Click on the number to
view and modify Sensor Parameters. See Figure 4.17.
Check: Each check box controls whether or not readings from the Connector /
Transmitter will be outputted. If unchecked, the readings from the Connector/Transmitter
will not be displayed on the "Readings", "Chart" and "Diagnostic" pages nor it will be
reported through Telnet.
Sensor Name: Name of a Connector/Transmitter shows on the "Readings" and "Chart"
pages, this is a text field and can take up to 8 alphanumeric characters.
Updates Seconds: How often a Connector/Transmitter sends its data to the Receiver.
Units: Type of data and the corresponding units. Units of measurement from sensors
inside a Connector/Transmitter that has joined the network will be displayed. [ºC,ºF or %].
Update Checked Box: After checking/unchecking the boxes, make sure this is clicked to
save the changes.
SENSOR SETUP
Check
Sensor Name Update Seconds
ABCDEFGH
LAB 50
LAB 100
CLN RM1
CLN RM2
ABCDEFGH
OVEN5
ABCDEFGH
Click on Sensor # to modify Sensor Parameters
Update Checked Box
Select Another Group
Figure 4.16 Sensor Setup
120
120
120
120
120
120
120
120
Readings
Charts
Main Menu
26
Units
--
C, K Type
C, K Type
C, Pt. RTD
C, I.R.
--
%, R.H.
--
Advertisement
Table of Contents
