Part 2 Hardware; Parts Of The Receiver; Figure 2.1 Parts Of The Receiver - Omega Engineering UWTC-REC3 User Manual

PART 2 HARDWARE

2.1 Parts of the Receiver

1 Wall mounting bracket clip holes (3 places)
2 Label with model and serial numbers
3 Receiver's firmware revision on label
4 8 position DIP switch, only the 1st position is used (see Section 4.3.1 for details)
5 Ethernet: RJ45 interface for 10BASE-T connection.
6 Case's tray, where the PCB is mounted
7 4 position DIP switch, sets the DHCP and Factory Defaults
8 Receiver's radio module firmware revision on label
9 Label with default IP address, remove and then write your IP address, in the space
provided
10 Label with MAC address (in hex code)
11 Wall mounting bracket
12 Case's cover mounting screw (2 places)
13 Power LED: (Green) Solid: Indicates Power-ON
14 Power supply: Plus (+) power supply wire connection inside the plug;
Minus (-) power supply wire connection outside the plug
15 Reset button: Used for power reseting the Ethernet board
16 Case's cover

Figure 2.1 Parts of the Receiver

4