Honda HRA-21 Owner's Manual page 22

3. Pull the starter rope until resistance is felt. This
closes the valves and helps to protect the com-
bustion chamber from corrosion.
4. Remove dirt and debris from the underside of the
mower housing. Clean the mower thoroughly. Paint
areas that may rust with a rust-resistant paint, or
coat with a light film of oil.
5. Cover the mower and store it on a level surface
in a dry, dust-free area.
Removal From Storage
1. Remove the spark plug; check that it is clean and
properly gapped (p. 25). Pull the starter rope sev-
eral times.
2. Thread the spark plug in as far as possible by hand,
then use the plug wrench to tighten l/8 to l/4 turn
further.
3. Check the engine oil level and condition.
4. Fill the fuel tank and start the engine.,
NOTE:
If the cylinder was coated with oil, the engine will
smoke at start up; this is normal.
STARTER HANDLE
20