Charging Your Helicopter - Brookstone u-Control Instruction Manual

CHArGING yOur HelICOPter

1. Make sure the ON/OFF SWITCH on the
helicopter is set to the OFF position.
2. Slide CHARGING PLUG COMPARTMENT
cover on the front of remote control
to the open position to access the
CHARGING PLUG.
3. Connect the CHARGING PLUG on the
controller to the CHARGING SOCKET
on the helicopter, making sure the prongs
match the plug holes (see Figure 1).
4. Turn the REMOTE's ON/OFF SWITCH
to the ON position. The green and red
lights on the REMOTE will illuminate,
indicating that charging is in process.
Note: the length of charging time will vary depending on percentage of
battery already charged and strength and condition of the AA batteries
in the charger. Average charge time is 20-25 minutes.
5. The green charging indicator will shut off when the helicopter is fully charged.
6. Unplug the CHARGING PLUG from the CHARGING SOCKET and store in
the CHARGING PLUG COMPARTMENT so it doesn't interfere with the controls.
5
figure 1