Honda CR-V 2006 Owner's Manual page 236

Jump Starting
BRACKET
Remove the power steering
4.
reservoir from the bracket. Pull it
away from the grounding strap.
Make sure the power steering
hose is not touching the power
steering belt or the pulley.
230
Connect the second jumper cable
5.
to the negative ( ) terminal on
the booster battery. Connect the
other end to the grounding strap
as shown. Do not connect this
jumper cable to any other part of
the engine.
6. If the booster battery is in another
vehicle, have an assistant start
that vehicle and run it at a fast idle.
7. Start your vehicle. If the starter
motor still operates slowly, check
that the jumper cables have good
metal-to-metal contact.
8. Once your vehicle is running,
disconnect the negative cable from
your vehicle, then from the
booster battery. Disconnect the
positive cable from your vehicle,
then from the booster battery.
9. Reinstall the power steering
reservoir.
Keep the ends of the jumper cables
away from each other and any metal
on the vehicle until everything is
disconnected. Otherwise, you may
cause an electrical short.