Honda CR-V 2006 Owner's Manual page 120

Playing a Tape
To Play a Tape
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Make sure the open side of
the tape is facing right, then insert
the tape most of the way into the slot.
The system will pull the tape in the
rest of the way and begin to play it.
The tape direction indicator in the
display comes on to show you which
side of the tape is playing. The
indicates the side you inserted
upward is now playing. If you want to
play the other side, press the PROG
button. When the player reaches the
end of the tape, it will automatically
reverse direction and play the other
side.
114
Dolby noise reduction turns on
when you insert a tape. The
indicator will light in the
display. If the tape was not recorded
in Dolby, turn it off by pressing the
button. Dolby remains off until
you press the button again.
Dolby noise reduction is manufactured under
license from Dolby Laboratories Licensing
Corporation. ''DOLBY'' and the double-D symbol
are trademarks of Dolby Laboratories
Licensing Corporation.
To Stop Playing a Tape
To remove the tape, press the eject
button. If you want to turn the player
off, press the PWR/VOL knob or
turn off the ignition. The tape will
remain in the drive. When you turn
the system back on, the tape will
begin playing where it left off.
To switch to the radio or CD player
while a tape is playing, press the AM,
FM, or CD button. To change back
to the tape player, press the TAPE
button.
Tape Search Functions
FF/REW To rewind the tape,
push the REW button. You will see
REW in the display. To fast forward
the tape, push the FF button. You
will see FF displayed. Press the FF,
REW, or PLAY button to take the
system out of rewind or fast forward.
SKIP Press the button to find
the beginning of the current song or
passage. Press the button to find
the beginning of the next song or
passage. When the system reaches
the beginning of a song or passage, it
begins to play it.