Honda CR-V 2006 Owner's Manual page 131

To Play a CD
To load or play CDs, the ignition
switch must be in the ACCESSORY
(I) or the ON(II) position.
You operate the CD player/CD
changer with the same controls used
for the radio. To select the CD
player/CD changer, press the CD
button. The number of the track
playing is shown in the display. With
the in-dash CD changer, the disc and
track numbers are displayed. The
system will continuously play a CD
until you change modes.
You can also play 3-inch (8-cm) discs
without using an adapter ring.
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
To play the radio when a CD is
playing, press the AM/FM button.
Press the CD button again to switch
back to the CD player.
To play the tape when a CD is
playing, insert a tape in the player. If
a tape is in the player, press the
TAPE button. Press the CD button
again to switch back to the CD
player.
If you turn the system off while a CD
is playing, either with the PWR/VOL
knob or by turning off the ignition,
the disc will stay in the drive. When
you turn the system back on, the CD
will begin playing where it left off.
Playing a Disc
Loading CDs in the In-dash CD
Changer
Your vehicle's in-dash CD changer
holds up to six discs.
1. Press the LOAD button until you
hear a beep and see ''LOAD'' in
the display.
To load only one CD, press and
release the LOAD button.
2. The disc number for an empty
position is highlighted.
3. Insert the disc into the CD slot
when the green CD load indicator
comes on. Insert it only about
halfway; the drive will pull it in the
rest of the way. You will see
''BUSY'' in the display while the
CD load indicator turns red and
blinks as the CD is loaded.
You cannot load and play 3-inch
(8-cm) discs in this system.
CONTINUED
125