Changing a Flat Tire
Hard plastic spare tire cover
If equipped
7.
Unzip the flap around the lower
edge of the cover.
8.
Pull out the bottom of the cover,
then gradually pull it off.
222
CENTER SPACER
9.
Pull off the center spacer. Using
the wheel wrench, loosen the
three wheel nuts and remove them.
Remove the spare tire from the
holder.
10.
Loosen each wheel nut 1/2 turn
with the wheel nut wrench.
NUTS
JACKING POINT
11.
Place the jack under the jacking
point nearest the tire you need to
change. It is pointed to by an
arrow molded into the underside
of the body. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the center of the jacking
point tab is resting in the jack
notch.