Operation - Audio Note M2 Line Balanced Owner's Information

Once all the connections are completed and checked, ensure that the volume control
is at the minimum setting (rotated all the way left).
Ensure that all source components connected to the M2 Line Balanced Pre
Amplifier are switched ON. Source components should always be the FIRST
components to be switched on and the LAST components to be switched off.
Ensure that all power amplifiers connected to the M2 Line Balanced Pre
Amplifier are switched OFF. Any power amplifiers in use should be the LAST
components to be switched on, and the FIRST components to be switched off.
The above procedure minimizes the possibility of loud noises produced by
components at switch on being passed to the loudspeakers and possibly causing
damage.
Turn on the M2 Line Balanced Pre Amplifier by using the rocker switch located on the
rear panel, above the mains inlet IEC socket.
The M2 Line Balanced Pre Amplifier requires approximately 45 seconds to initialize
before it is ready for operation.
Input Selector
Source / Tape
Volume Control
Balance Control

OPERATION

Turn the selector to the source you wish to listen to.
This allows you to switch between the selected source input
and the output of your recording device.
This control adjusts the listening level, or loudness. Set as
desired!
This control adjusts the relative left/right levels. Use this control
if necessary to equalize the loudness from each speaker.