Removal From Storage - Honda H3013H Owner's Manual

7. For longer service and greater efficiency, keep the underside of the
mower housing clean and free of accumulated grass clippings by
washing it down with a hose after use and/or cleaning it with a wire
brush and scraper. Remove any rust and apply a rust-resistant paint.
Cleaning and rust prevention are especially important before seasonal
storage.
6. Reinstall the cutter deck by reversing the removal procedure.
9. Store the riding mower on a level surface in a dry, dust-free area with
the parking brake lever set.
10. Cover the riding mowerto keep out dust.
11. Check tire air pressure regularly during storage and inflate if
necessary.
Removal from storage
1. Check the battery electrolyte level (see page 23). Fully recharge the
battery, and install it in the riding mower.
2. Remove the spark plug and check that it is clean and properly gapped
(see pages 47-46).
Turn the engine a few revolutions with the starter motor before
reinstalling the spark plug.
3. Thread the spark plug in as far as possible by hand, then tighten it l/8
to l/4 turn further with the plug wrench.
4. Check the engine oil level (see page 18).
5. Fill the fuel tank, and start the engine by following the starting instruc-
tions (see pages 30-31 I.
NOTE: If the cylinder was coated with oil, the engine will initially smoke
at start up; this is normal.
64