Using The Configuration Menu - D-Link AirPro DWL-6000AP User Manual

5. Using the Configuration Menu

The Configuration Menu for the DWL-6000AP is web-based. When using the configuration program,
please consider the following:
You will need a JavaScript-enabled web-browser such as the Internet Explorer
4.0 or higher, or the Netscape Navigator 4.0 or higher.
The computer that you are using for initial configuration must have an IP
Address within the same range as the IP Address of the DWL-6000AP. The
DWL-6000AP has a default IP Address of
255.255.255.0 The range of compatible computer IP settings is as follows:
computer IP Address = 192.168.0.1 – 192.168.0.49 or 192.168.0.51-
192.168.0.254 and a subnet mask = 255.255.255.0
If you are using a D-Link router in your network, such as the DI-604, with the
factory default settings, you will not need to assign a static IP Address to the
computer that you are using to configure the Access Point. (Skip to Fig. 5.1:
entering the IP address)
If you are not using a DHCP enabled router to assign IP settings on your
network, you will need to assign a Static IP Address to the computer that you
are using to configure the DWL-6000AP, within the IP Address Range of the
DWL-6000AP. (Please see Networking Basics in this manual for information
on Assigning a Static IP Address.) Please make a note of your initial IP
Address, you will need to re-enter it later!
After you have assigned a Static IP Address to the computer you are using for
configuration (if necessary), you need to assign the DWL-6000AP an IP
Address within the IP Address range of your existing network.
In order to regain connection to the DWL-6000AP, after changing its IP
Address, revert to the IP address that you had for this computer before
you began the configuration, as follows:
• If this computer had a static IP address re-input that same address.
ESSID
Channel
WEP
User Name
Password
IP Address
AirPro DWL-6000AP
Factory Default Settings for the DWL-6000AP
default
Channel depends on regional settings
disabled
admin
(no password, leave field blank)
192.168.0.50
192.168.0.50 with subnet mask
8