Configure Wpa/Wpa2 Personal - D-Link DHP-W306AV User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption
due to the added overhead.
1. Log into the web-based configuration by opening a web browser
and entering the IP address of the access point (192.168.0.50).
Click on Setup and then click Wireless Settings on the left
side.
2. Next to Security Mode, select Enable WPA Wireless
Security, Enable WPA2 Wireless Security, or Enable WPA2-
Auto Wireless Security.
3. Next to Cipher Type, select TKIP, AES, or Auto.
4. Next to PSK / EAP, select Personal.
5. Next to Passphrase, enter a key. The key is entered as a passphrase in ASCII format at both ends of the wireless
connection. The passphrase must be between 8-63 characters.
6. Click Save Settings at the top of the window to save your settings. If you are configuring the access point with a
wireless adapter, you will lose connectivity until you enable WPA-PSK on your adapter and enter the same passphrase
as you did on the access point.
D-Link DHP-W306AV User Manual

Configure WPA/WPA2 Personal

46