Using Powerline Carrier Device Commands; Device Descriptions - Honeywell ADEMCO LYNXR User Manual

Powerline Carrier devices (e.g. X-10 brand devices) are programmable switches that can be used to
perform many different functions. Your system may be set up so that certain lights or other devices can
be turned on or off by using the device command from the keypad. Ask your installer if this has been
done in your system. If programmed for your system, some devices may activate automatically upon
certain system conditions. In this case, the following commands can be used to override the device
activation. See your installer for a full explanation of this feature.
To activate X-10 devices 1-6:
To deactivate X-10 devices 1-6:
To activate X-10 devices 7 & 8**:
To deactivate X-10 devices 7 & 8**:
** Devices 7 and 8 may be assigned to system devices, such as alarm bells, which should not be
activated using this command because they are activated automatically under certain system
conditions. See your installer and the table below.
See your installer for device numbers assigned for your system.
Device
1
2
3
4
5
6
7
8
Your user code
Description
– 22 –