Honda Outboard Motor BF135A Owner's Manual page 69

3. Remove the two mud guard clips
from the upper part of the under
cover grommet.
To remove the mud guard clips,
raise the inner part of each mud
guard clip with a screwdriver, then
pull out the clips.
Do not try to remove the mud guard
clip with f orce without raising the
inner part of the mud guard clip.
Otherwise, it can damage the mud
guard clip and/or under cover.
4. Fold down the upper part of the
under cover grommet without
removing it from the idle port.
SERVICING YOUR OUTBOARD MOTOR
SPARK PLUG COVER
5. Remove the two bolts with the 6
mm hex wrench, and remove the
spark plug cover.
BOLTS
WIRE CONNECTOR
6. Use a hex. wrench to remove the
bolt holding the ignition coil.
Move the ignition coil to a position
that allows removal of the wire
connector easily.
7. Disconnect the wire connector
from the ignition coil by pushing
on the lock tab and pulling on the
connector. Pull on the plastic
connector, not the wires.
IGNITION COIL
BOLT
67