Table of Contents
Advertisement
4) Tub
Turn the air guide nut counter-clockwise.
(Special tool might be needed.)
Be careful the rubber packing of air
guide assembly should not be lost.
Turn the softner cap and nut counter-
clockwise.
Remove 4 screws for sump holder .
Remove side 8 screws.
Remove 2 Earth screw of right side.
Lift tub assembly upward.
(Be sure water softner is not blocked.)
Be careful not to be injured or scratch
floor by the sharp edge of tub.
9. Air Guide Assembly
Disconnect the wiring connection.
Remove 3 hoses assembly.
Be careful the o-ring should not be lost.
10. C-Base Assembly
1) Remove the screw which tighten washing
motor and base.
2) Lift them upward.
Be careful not to wet the floor by the
water left in the sump.
3) Pull out the float switch with pressing
downward softly.(not on all models)
4) Detach the washing motor and heater
assembly by pulling opposite direction
to sump.
5) Remove the 3 screw for drain motor.
- 16 -
Advertisement
Table of Contents
