Removing The Unit - Kenwood DDX418 Instruction Manual

Removing the Unit

1
Remove the escutcheon by referring to
the removal procedure in the section
<Removing the Escutcheon>.
Insert the two removal tools 6 deeply into
2
the slots on each side, as shown.
3
Lower the removal tool toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
⁄
• Be careful to avoid injury from the catch pins on
the removal tool.
4
Pull the unit all the way out with your
hands, being careful not to drop it.
Installing the Microphone Unit
(DDX418/DDX4048BT only)
1
Check the installation position of the
microphone (accessory 7).
2
Remove oil and other dirt from the
installation surface.
3
Install the microphone.
Accessory 6
4
Wire the microphone cable up to the unit
with it secured at several positions using
tape or the like.
⁄
• Install the microphone as far as possible from the
cell-phone.
Peel the release coated paper of double-face
adhesive tape to fix on the place shown above.
Adjust the direction of the microphone to the driver.
Accessory 7
Fix a cable with a commercial item of tape.
7
English