How To Use; Unpacking; Product Features; Assembly - Homeright Power-Flo Instruction Manual

UNPACKING

When unpacking check to make sure that the item is intact and undamaged. If any parts are
missing or broken, please call the number on the front of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
WARNING: To prevent serious injury from accidental operation, turn the Power Switch
(Figure C ) of the High Pressure Airless Sprayer to its "OFF" position and unplug the Sprayer
from its electrical outlet before assembly procedures.
NOTE: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram near the end of this manual.
Remove the protective Plastic Cap from the Paint Output Coupler. Then attach the High
Pressure Paint Hose. (Figure A ) Attach spray gun to other end of hose. Tighten with wrench.
Do not attach spray tip and guard.

PRODUCT FEATURES

• Pressure Adjust Knob: The Pressure Adjust Knob controls the output pressure of paint.
Turn the Knob clockwise to increase pressure and counterclockwise to decrease pressure.
(Figure B)
• Power Switch: Press to turn the Sprayer on or off. (Figure C )
• Prime/Spray Knob: Turn the Prime/Spray Knob horizontally to run the Sprayer.
Turn the knob vertically to run the Sprayer in its prime/clean" mode. (Figure D )
• Output Coupler: The Spray Gun Hose connects to the paint Output Coupler. (Figure A )
• Siphon Hose: The Siphon Hose sucks paint from the container into the Spray Gun.
(Figure E )
• Return Tube: When system pressure is released or when priming pump, the paint flows
from the Return Tube. (Figure E )

HOW TO USE

POWER-FLO PRO
®
8
Meijer.com
A
Output coupler
B
b a r /M
P a /p
s i
C
D
Prime Spray
E
Return Hose
Siphon Hose
ENGLISH