Installing a 2.5-inch Hard Drive
1 Align the 2.5-inch hard drive bracket on the new hard drive then replace
the four screws.
Figure 3-10. Aligning the 2.5" Hard Drive Bracket
NOTE:
The correct orientation of the bracket is with the arrow mark pointing
towards the hard drive connector.
2 Connect the hard drive to the hard drive board in the sled.
Figure 3-11. Connecting the 2.5" Hard Drive to the Hard Drive Board
3 Replace the sled hard drive bracket screws underneath the sled.
2.5" HDD
2.5" HDD
HDD0
HDD1
2.5" HDD
2.5" HDD
HDD2
HDD3
Installing System Components
111