Table of Contents
Advertisement
Basic Adjustment
Manually tuning channels
Manual Tune
You can manually tune new services after the first
time installation has been completed.
1
Press / to select the desired UHF
channel.
2
Press to select 'Frequency' (kHz).
3
Press / to adjust the frequency.
4
Press to select 'Bandwidth'.
5
Press / to adjust the bandwidth.
6
Press to select 'System'.
7
Press / to select a system.
8
Press the
button to start scanning for
the specified channel. If the channel is
found it will be stored in the Receiver and
will be available in the channel list and EPG.
Item
UHF Channel
Select channel 21-68
Frequency
The frequency of the service
(channel) you are manually tuning.
Bandwidth
The bandwidth of the service
(channel) you are manually tuning.
System
The type of tuning system.
DVB-T = SD (Default)
DVB-T2 = HD
NOTE
•
You can enter the UHF channel and frequency
using the 0-9 numeric buttons.
First Time Installation
This function allows you to perform a first time
installation.
1
Press Menu on your remote control
2
From the Menu options on screen,
select Settings
3
Then select General
4
Use the navigation buttons to highlight
First Time Installation
5
Press OK to select.
6
A warning banner will be shown.
Press OK to proceed or exit to cancel.
7
Press OK to scan for new services.
You may have to wait a couple of minutes
for the scan to complete.
8
You will receive a message to confirm when
installation is complete.
9
Press OK to start watching TV
24
Advertisement
Table of Contents
