Table of Contents
Advertisement
Basic Adjustment
General
Auto Standby
This function allows you to automatically switch
the Receiver into standby mode when there is no
user activity for 3 hours.
Item
Enabled
The Receiver will automatically switch
(default)
into standby mode when there is no user
activity for 3 hours.
Disabled
The Receiver will remain on constantly
unless switched into standby mode by
the user.
Power Save in Standby Mode
This function allows you to control the power
saving features of your Receiver.
Item
Enabled
The Receiver uses a very low amount of
(default)
power when in standby.
Disabled
Power saving features are disabled.
Upgrade Software
This function allows you to control when software
upgrades are installed.
Automatic The receiver will automatically install
software upgrades when available
Manual
The receiver will display a message
allowing you to confirm or cancel
the software upgrade
Auto Retune
This function allows you to control when new
services (channels) are added and stored on
the Receiver.
Always
Whenever new services (channels)
Start
are detected, the Receiver will
automatically tune and store them.
Always
Whenever new services (channels)
Ask
are detected, a message will appear
on screen. You can choose to tune
and store the new services or cancel
the auto retune.
Auto Retune Messages
This function controls when retune messages
are displayed.
All
All messages are displayed.
No Minor
Only major messages are displayed.
Messages
Information Only information messages are
Messages
displayed.
None
No messages are displayed
NOTE
•
During the digital switchover, Auto retune
messages may be displayed. Follow the on-
screen instructions to retune.
23
Item
Item
Item
Advertisement
Table of Contents
