Table of Contents
Advertisement
Setting up
Replace the cover (reverse procedure as with the remove of the cover).
Press the replace key
activated.
Placing the handset on the base station
Place the handset on the base station with the display pointing upwards. The
confirmation tone sounds and the bars of the battery status icon in the display
begin to move.
Leave the handset in the charging cradle so that the batteries can be charged.
• The fist time you charge the batteries, we recommend an uninterupted
charging time of at least 15 hours, regardless of the charge level
display.
• When the batteries are new, they doesn't provide 100% of them
efficiency; it means that they might be discharged earlier. To reach the full
battery duty, you have to "run-in" the batteris with at least 3-4 deep
charging / discharging cycles, after that they will reach their maximum
capacity.
• With the daily use, it is not necessary to place the handset to the base
after each call. It is better for the batteries, if they load themselves nearly
to empty and then again fully.
• The batteries warm up during charging; this is a perfectly normal
process and is not dangerous.
• The charge level for the batteries displayed is only correct after an
uninterrupted charging / discharging process. You should not,
therefore, open the battery compartment unnecessarily.
•
The charge level display is used for orientation of the remained energy
reserve.
Setting the display language
When setting up, the telephone allows you to select the language, you prefer.
The language-selection appears in the display.
Press the arrow keys to choose the desired language, and press the
OK soft key to confirm.
for at least 2 seconds. The handset will be
10
Advertisement
Table of Contents
