Honda 08E91-E22-100B Installation Instructions Manual page 13

www.collegehillshonda.com
40. Wrap the vehicle 7-pin connector with one foam
cushion tape, then place the vehicle 7-pin
connector into the gap of the column.
VEHICLE 7-PIN
CONNECTOR
(brown)
(Squeeze into
this area.)
FOAM
CUSHION
TAPE
VEHICLE 7-PIN
VEHICLE
CONNECTOR
BRACKET
41. Secure the engine starter harness to the vehicle
harness with four wire ties in the areas shown.
The lock of the wire ties should face up.
42. Remove the lower steering column support
bracket bolt. Attach the relay bracket to the
steering column support bracket and reinstall the
steering column support bracket bolt.
STEERING COLUMN
SUPPORT BRACKET
BOLT (Reuse.)
© 2008 American Honda Motor Co., Inc. - All Rights Reserved.
ENGINE STARTER
HARNESS
GREEN
4 WIRE
TAPE
TIES
VEHICLE
LOCK
HARNESS
WIRE
TIE
ENGINE
STARTER
VEHICLE
HARNESS
HARNESS
6D01111T
STEERING
COLUMN
SUPPORT
BRACKET
RELAY
BRACKET
6D01063T
AII 38215-38958 (0802)
43. At the right of the steering shaft, locate the sub
joint box. Using a small flat-tip screwdriver, unplug
the vehicle 6-pin connector from the sub joint box.
Plug the engine starter harness 6-pin connectors
into the vehicle 6-pin connector and the subjoint
box.
VIEWED FROM
UNDERSIDE
FRONT
ENGINE STARTER
HARNESS 6-PIN
CONNECTOR
44. Attach the relay blocks and fuse case on the relay
bracket.
RELAY
BRACKET
FUSE
CASE
RELAY
BLOCK
45. Secure the engine starter harness to the vehicle
harness using a wire tie.
VEHICLE 6-PIN
CONNECTOR
SUB JOINT
BOX
VEHICLE 6-PIN
6D01162T
CONNECTOR
VEHICLE
HARNESS
WIRE
TIE
ENGINE STARTER
6D01302T
HARNESS
13 of 22