ECS PF4 Extreme User Manual page 33

ration number from 0 to 255.
TM2 Bus VID [0.8375V]
This item helps you to set the voltage of the throttled performance that will be initiated when the on
die sensor goes from not hot to hot.
Limit CPUID MaxVal [Disabled]
This item limits the CPUID maximum value. Enable this item to install WinNT. Leave this item at
the default value for other OS.
Press <Esc> to return to the Advanced BIOS Features page.
Hard Disk Boot Priority (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Phoenix-AwardBIOS CMOS Setup Utility
1. Pri.Master:
2. Pri.Slave:
3. Sec. Master:
4. Sec. Slave:
5. USBHDD0:
6. USBHDD1:
7. USBHDD2:
8. Bootable Add-in Cards
: Move PU/PD+/-/:Change Priority
F5:Previous Values F6:Fail-Safe Defaults
3-6
Hard Disk Boot Priority
Item Help
Menu Level
Use < > or < > to
select a device, then press
<+> to move it up, or <-> to
move it down the list. Press
<ESC> to exit this menu.
F10:Save ESC:Exit
F7:Optimized Defaults
CPU L3 Cache [Enabled]
Some high-end processors support L3. If the CPU do support L3, you may set this
item to enable or disable. Leave this item at the default value for better performance.
Hyper-Threading Technology [Enabled]
This item is only available when the chipset supports Hyper-Threading and you are
using a Hyper-Threading CPU.
Quick Power On Self Test [Enabled]
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
First/Second/Third Boot Device [Floppy/Hard Disk/CDROM]
Use these three items to select the priority and order of the devices that your system
searches for an operating system at start-up time.
Boot Other Device [Enabled]
When enabled, the system searches all other possible locations for an operating
system if it fails to find one in the devices specified under the First, Second, and
Third boot devices.
Boot Up Floppy Seek [Disabled]
If this item is enabled, it checks the size of the floppy disk drives at start-up time.
You don't need to enable this item unless you have a legacy diskete drive with 360K
capacity.