Advanced Bios Features - ECS PF4 Extreme User Manual

Halt On [All Errors]
This item defines the operation of the system POST (Power On Self Test) routine.
You can use this item to select which types of errors in the POST are sufficient to
halt the system.
Base Memory, Extended Memory and Total Memory
These items are automatically detected by the system at start up time. These are
display-only fields. You cannot make chanages to these fields.

3.3-2 Advanced BIOS Features

This option defines advanced information about your system.
Phoenix-AwardBIOS CMOS Setup Utility

Advanced BIOS Features

CPU Feature [Press Enter]
Hard Disk Boot Priority [Press Enter]
CPU L3 Cache [Enabled]
Hyper-Threading Technology [Enabled]
Quick Power On Self Test [Enabled]
First Boot Device [Floppy]
Second Boot Device [Hard Disk]
Third Boot Device [CDROM]
Boot Other Device [Enabled]
Boot Up Floppy Seek [Disabled]
Boot Up NumLock Status [On]
Gate A20 Option [Fast]
Typematic Rate Setting [Disabled]
Typematic Rate (Chars/Sec0 6
X
Typematic Delay (Msec) 250
X
Security Option [Setup]
APIC Mode [Enabled]
: Move Enter: Select +/-/PU/PD:Value
F5:Previous Values F6:Fail-Safe Defaults
Item Help
Menu Level
F10:Save ESC:Exit F1: General Help
F7:Optimized Defaults
CPU Feature (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Phoenix-AwardBIOS CMOS Setup Utility
Delay Prior to Thermal [16 Min]
Thermal Management [Thermal Monitor 1]
TM2 Bus Ratio [0X]
TM2 Bus VID [0.8375V]
Limit CPUID MaxVal [Disabled]
: Move Enter: Select
F5:Previous Values F6:Fail-Safe Defaults
Delay Prior to Thermal [16 Min]
Enables you to set the delay time before the CPU enters auto thermal mode.
Thermal Management [Thermal Monitor 1]
This item sets CPU's thermal control rule to protect CPU from overheat.
feature is only available when CPU supports Thermal Monitor 2.
TM2 Bus Ratio [0 X]
This item helps you to set the frequency (bus ratio) of the throttled performance that
will be initiated when the on die sensor goes from not hot to hot. You may set the bus
CPU Feature
Item Help
Menu Level
+/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F7:Optimized Defaults
This
3-5