Reliable i500 Instruction Manual page 14

TROUBLESHOOTING
PROBLEM
Does It may happen that, while filling the
steam go tank, some water overfills the cap
out from and flows inside the boiler wetting
the boiler? the insulating material
Does the 1) While filling the tank you may
nozzle or have poured too much water into it.
gun leak
water
mixed with
steam?
There is 1) The steam knob (where
no steam supplied) might be closed
coming out
of the 2) The foot pedal is not plugged in
nozzle or (i500B)
gun?
3) The boiler switch might be off
4) The water might be used up.
Does the Some dirty might have gone into
steam leak the tank with the water and it is
dirty given off from the iron.
water?
EXPLANATION SOLUTION
In order to solve the problem, we suggest
using the machine as usual so that the
insulating material dries up in about one
hour through the heat of the machine. In
case you still have this problem after one
working hour, please contact the service
centre.
1) The problem will go on until the excess
water is emptied. Keep the steam button
depressed until the water in the tank is at
the correct level.
1) Open the steam knob anticlockwise.
2) Plug the 4-pin receptacle into the boiler.
3) After the boiler switch comes on, wait for
10 minutes so the boiler produces steam.
4) Fill it following the instructions carefully.
Fill the empty tank with 1 liter of water,
screw the cap up, shake it, unscrew the
cap and empty the tank. Repeat the action
until the water is cleaned. We do not
recommend the use of any additive to pour
in the tank. Before ironing again spray
some steam on a cloth until clean steam
comes out.