LG LD-1426T Service Manual page 44

Drain Hose Extension
Drain Hose extension kits are available from through your local service centre.
Extend drain Hose as shown below. (Refer to Fig. C)
Fig. C
Sink
Use the couplings for connections when you
extend drain hose.
Drain hose extension or 16-20mm inside fl rubber
hose able to withstand 90ßC hot water
Step 6 : WATER SUPPLY CONNECTION
1. Connect the water supply hose to the valve behind dishwasher
and the water tap as shown in figure. (Refer to Fig. D. E)
This dishwasher may be fed with either hot or cold water. If the
water can not be maintained below 65°C, the dishwasher must
be connected to cold water.
2. When connecting, the sealing tape or sealing compound should
be used to avoid water leaks.
Make sure that the line is not kinked or sharply bent.
Step 7 : FINAL CHECK AND ASSEMBLING
1. Securely hand tighten supply hose to water supply.
Plug power cord into an earthed power point and switch on.
2. Operate the dishwasher through one cycle (Quick cycle is recommended) to check for water leak
and operating conditions.
200 mm Max.
Copper pipe
fl 20mm flared
at drain nose
and other end
if required.
- 44 - - 44 -
Fig. D
Fig. E