LG LD-1426T Service Manual page 29

4) Tub
8. Air Guide Assembly
9. C-Base Assembly
1) Remove the screw which tighten washing
2) Lift them upward.
LD-1426T
LD-1416T
3) Pull out the float switch with pressing
LD-1415M
4) Detach the washing motor and heater
5) Remove the 3 screw for drain motor.
- 29 - - 29 -
Turn the air guide nut counter-clockwise.
(Special tool might be needed.)
Be careful the rubber packing of air
guide assembly should not be lost.
Remove 4 screws for sump holder .
Remove side 8 screws.
Remove 2 Earth screw of right side.
Lift tub assembly upward.
Be careful not to be injured or scratch
floor by the sharp edge of tub.
Disconnect the wiring connection.
Remove 3 hoses assembly.
Be careful the o-ring should not be lost.
motor and base.
Be careful not to wet the floor by the
water left in the sump.
downward softly.(not on all models)
assembly by pulling opposite direction
to sump.