Powering The Transmitter Cradle Off; Synchronising The Headphones And Transmitter Cradle - Silvercrest RFH 2401 User Manual And Service Information

Wireless
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
SilverCrest RFH 2401

Powering the Transmitter Cradle Off

You may power the transmitter cradle off whenever it is not needed. When
powered off, it will not transmit any RF signals but the headphones battery
will still be charged.
1. Slide the On/Off switch (15) on the transmitter cradle to the "OFF"
position. The send indicator (17) on the transmitter goes out.
You may optionally power the transmitter cradle using conventional
batteries. For more information see page 20 – Powering the Transmitter
Cradle Using Batteries.
Synchronising the Headphones and Transmitter
Cradle
After powering the headphones and the transmitter cradle on, both devices
should synchronise automatically. This process may take a while
(sometimes more than 1 minute), but normally you just have to be patient.
Under unfavourable circumstances, however, the audio signal may be
subject to interference. This may happen if you are using a baby phone or
a wireless keyboard and mouse set nearby. In this case you can
synchronise the devices manually to locate an interference-free channel.
1. Power the transmitter cradle on by sliding the On/Off switch (15) on the
transmitter cradle to the "ON" position.
2. Power on the connected audio source and start playback. The send
indicator (17) on the transmitter cradle should light up green.
3. Slide the mode selection switch (4) of your headphones to the "WL"
position.
4. Power the wireless headphones on by pressing the On/Off button (10)
once.
5. Press and hold the synchronisation button (2) of the headphones and
the synchronisation button (14) of the transmitter cradle for at least 1
second.
The RF reception indicator on the headphones (5) and the send
indicator on the transmitter cradle (17) start blinking and a beep can be
heard. As soon as both devices have synchronised, both indicators will
light up green.
6. If necessary, repeat step 5 if you are not satisfied with the reception
quality or you still have interference from other devices.
English
15

Advertisement

Table of Contents
loading

Table of Contents