GE JV535 Owner's Manual And Installation Instructions page 11

REMOVE DUCT KNOCKOUT(S)
6
If recirculating, non-vented ductless (optional for
JV5 Series models only), see note below and skip to
Step 9 D and proceed. The JV6 Series models cannot be
recirculated.
Using a flat blade screwdriver, remove the appropriate
duct knockout(s) from the top or back of the hood.
" x 10" Rectangular
3
1 4
vertical discharge.
Remove top rectangular
duct knockout only.
NOTE: If the hood is to be installed in a recirculating, non-
vented ductless manner, order charcoal filters,
These kits can be ordered from your GE supplier.
Skip to Step 9 D and proceed.
Installation Instructions
" Round vertical discharge.
Remove semi-circular duct
knockout and top rectangular
duct knockout.
" x 10" Rectangular horizontal
3
1 4
discharge. Remove rear
rectangular duct knockout only.
" hood models, or
hood models.
"
" x 10" RECTANGULAR
FOR 3
1 4
DUCTED DISCHARGE INSTALLATIONS
ONLY:
Attach
damper pivot is nearest to
Remove tape from damper flap.
Up to 1" side-to-
side adjustment
Pivot
NOTE:
up to 1 inch on either side of the hood center to
installations, one end of the duct connector may need to
be trimmed to clear the electrical cable clamp.
" ROUND VERTICAL DUCTED
8
DISCHARGE INSTALLATIONS ONLY:
" round exhaust adaptor with its
screws, removed in Step 2 under the "Prepare the
Hood" section.
"
NOTE:
up to 1 inch on either side of the hood center to
installations, one end of the duct connector may need
to be trimmed to clear the electrical cable clamp.
" round damper is not included with
this product. It can be purchased as a kit by calling
800.626.2002. Order kit number JXDA22.
11
over knockout
of hood.
Top/back edge
(vertical discharge
position shown)
" round
adaptor
Tape