Table of Contents
Advertisement
Software Update Procedure
Software updates for the OmniaONE are performed over an Ethernet connection using any standard Web Browser
and an update file downloaded from the Omnia website. The OmniaONE contains two software banks and the new
software is always uploaded to the inactive bank. This is a safeguard against loss of power or other interruption
during the update. In this event, the OmniaONE should still boot into the active bank containing the "old" software
(but it is best to avoid interruptions in any case).
Special Note:
When updating an OmniaONE unit to version 2.0 from version 1.1 or earlier, you must update the unit to version 1.2
first (using the procedure below), run version 1.2, and then update the unit again from v1.2 to v2.0 (repeating the
procedure below a second time).
To update the OmniaONE software proceed as follows:
1. Download the OmniaONE software update file (.oup) from the Omnia website at:
http://www.omniaaudio.com/support/updates.htm
2. Make sure your OmniaONE's Network Configuration settings have been entered appropriately for your
network (see
Network Configuration
(Livewire) jack to your Ethernet network using a standard Cat.5 cable or directly to a computer using a
Cat.5 crossover cable.
3. Open a standard Web Browser on your computer and connect to the OmniaONE by entering:
http://xxx.xxx.x.xxx/ in the browser's address bar where the x's in the example above are replaced with the
OmniaONE's IP address. Once connected you should see the Login screen shown below. Enter the
Password (the default is "
"Enter")
4. The Main Menu should appear. Click on the "Firmware Update" link option.
5. The "Confirm Firmware Update" screen should appear with the following warning:
"Performing an update requires the controls and meters for the audio processor to be stopped. On-air audio
will not be interrupted during the update. However, a reboot is required to activate the new software, and
this will interrupt the audio. At the end of the process, you will have the option to change the current boot
bank (to activate the new software) and reboot or to keep running the current software and reboot later. Do
you want to continue the update process?"
If you would like to proceed after reading the warning message, click the "Continue" button and the
"Update File" dialog should appear:
and save it to a convenient location on your computer.
on Page 35 for details) and connect your OmniaONE's Ethernet
" – all lower case) and click on the "Login" button. (Or simply press
omnia
56
Hide quick links:
Advertisement
Table of Contents
