Table of Contents
Advertisement
Anlg Level (Analog Level)
Adjusts the master audio input level for the analog inputs, which are derived from the rear panel
XLR female input connectors. (See
Right Trim
Allows a +/-3dB adjustment of the right analog audio channel gain to correct minor left/right
balance problems in the input audio. The left channel analog input gain is not affected by this
control and is set using the master Analog Level control previously described.
AES Level (AES/EBU Level)
Adjusts the master audio input level for the AES Digital input, which is derived from the rear
panel RJ-45 StudioHUB
Right Trim
Allows a +/-3dB adjustment of the right digital audio channel gain to correct minor left/right
balance problems in the input audio. The left channel digital input gain is not affected by this
control and is set using the master AES Level control previously described.
LW Level (Livewire Level)
Adjusts the master audio input level for the Livewire input, which is derived from the rear panel
Ethernet / Livewire RJ-45 connector. (See
Right Trim
Allows a +/-3dB adjustment of the right Livewire audio channel gain to correct minor left/right
balance problems in the input audio. The left channel Livewire input gain is not affected by this
control and is set using the master LW Level control previously described.
Invert
Permits audio phase inversion to be performed in the following combinations:
[None] –
[Both] –
"Both" is typically selected if it sounds "better" to an announcer (monitoring themselves in
headphones using the output of the processing) than "None". One of the two settings should. The
goal is to make the relative phase of the headphone feed more in phase with the announcer's own
bone conduction. Once set, this setting should remain the same for all announcers using the same
headphone feed.
[L]
–
[R]
–
NOTE: These settings are present as a convenience to correct 180-degree stereo phase errors in
the input audio to the processor or in another device after the processor.
Proper Setting of Input Levels
®
connector. (See
Proper Setting of Input Levels
No Channel inversion is performed (factory default)
Both left and right channel phase is inverted.
Only the left channel phase is inverted.
O
nly the right channel phase is inverted.
29
on Page 11)
Proper Setting of Input Levels
on Page 11)
on Page 11)
Hide quick links:
Advertisement
Table of Contents
