Marmitek M229 Owner's Manual page 8

ENGLISH
M229-BASE STATION SETUP
Press and hold the left button (7) for 2 seconds. A beep indicates the system is in Setup mode.
A Menu is displayed on the monitor.
8
By pressing the left (7) and right (9) buttons you can step
through the Menu options.
With the middle (8) button you can change the settings.
• When the Memory LED [11] flashes quickly, the time
and date settings have to be programmed. Format for
date and time: YY/MM/DD HH:MM. The built-in
back-up battery will retain the time, date and stored
pictures during 1 hour in case of power failure.
• In case of power failure the settings will be retained.
• DR4/CAM3, DR3/CAM2, DR2/CAM1 should remain in
OFF position if no expansions are installed.
• Pick up the handset en replace it to exit the
Set-Up mode.
© MARMITEK