Table of Contents
Advertisement
English Manual
Factory Default Settings
Before configuring your, you need to know the following default settings.
Web Interface (Username and Password)
Username: admin
Password: admin
The default username and password are "admin" and "admin" respectively.
If you ever forget the username/password to login to the router, you may
press the RESET button up to 6 seconds to restore the factory default
settings.
Caution: After pressing the RESET button for more than 6 seconds, to be sure you
power cycle the device again.
Attention
Attention
Device LAN IP settings
IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0
ISP setting in WAN site
PPPoE
DHCP server
DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown as
below.
LAN Port
IP address
Subnet Mask
DHCP server function
IP
addresses
distribution to PCs
Chapter 3: Basic Installation
192.168.1.254
255.255.255.0
Enabled
for
100
IP
addresses
192.168.1.100 through 192.168.1.199
WAN Port
The PPPoE function is enabled
to automatically get the WAN
port configuration from the ISP.
continuing
from
21
Advertisement
Table of Contents
