Fresh Water Tank Filling - Leisure Serenity Owner's Manual

Water / Plumbing System
IMPORTANT
After connecting to the external water supply, open
the faucets in your Motorhome slowly and cautiously.
Air trapped in the line can cause the water to splash
into the sink. You may want to drape a washcloth
over the faucet to prevent excessive splashing.
4. Turn the water heater bypass valve (4), located on
the water heater to "NORMAL FLOW" to ensure
water enters the heater and hot water is available
for Motorhome use. The water heater is located in
a coach compartment (location varies according to
coach floorplan). Refer to the water heater owner's
manual located in the information kit for further
information.
Disconnecting
1. Turn "OFF" the city water supply.
2. Relieve water pressure in the line by opening a faucet
in the Motorhome.
3. Disconnect the hose from the city water connection
(1).
4. Replace the protective plug back over the city water
connection.

Fresh Water Tank Filling

City Water
1. Connect water hose to the city water inlet connection
(1).
2. Turn the water fill selector valve (2) to water tank fill -
handle vertical.
3. Turn "ON" the city water supply.
4. Depress and hold the fresh water tank level switch (3)
to show the level percentage in the LED display (4).
Once the fresh water level reads full on the monitor
panel, turn off the city water supply.
5. Turn the water pump switch (5) on the system monitor
panel to the "ON" position.
6. Slowly open the cold water tap until the water runs
smoothly. Repeat with the hot water taps.
Potable Water
When a city water supply connection is not available,
the fresh water tank can be filled using the following
procedure.
1. Fill a suitable water container with potable water.
2. Place the suction hose (6) attached to the winterize
by-pass valve into potable water container.
1-58
Serenity / Libero Motorhome
3
7
NOTE: The winterize by-pass valve is located
in seating, bed cabinet or road side exterior
compartment .
3. Turn the by-pass valve (7) to "WINTERIZE."
4. Turn the water pump switch (5) on the system monitor
panel to the "ON" position.
5. Depress and hold the fresh water tank level switch (3)
to show the level percentage in the LED display (4).
Once the fresh water level reads full on the monitor
panel, turn water pump "OFF."
6. Turn the by-pass valve (7) to "NORMAL FLOW."
B
2
A
1
4 5
6