Lp Gas Furnace - Leisure Serenity Owner's Manual

Appliance & Equipment Operation

LP Gas Furnace

Operation
The LP gas furnace is controlled by the single zone
thermostat (1) located in the coach living area.
Caution
Before operating the thermostat, carefully read and follow
the operating instruction in the LP gas furnace manual
located in the information kit.
Operating Tips
IMPORTANT
The furnace should not be operated when the vehicle
is moving.
1. Make sure the LP gas valve switch (2) located in the
rear utility center is turned "ON." See section entitled
"Liquid Propane Gas System" for details.
2. The furnace has no pilot light but is ignited by a direct
spark ignition system. No manual lighting is required.
3. DO NOT attempt to light the burner manually.
4. If the thermostat is set 4 degrees above the current
room temperature, the blower will come on.
5. If the burner fails to light, check the propane level at
the system monitor panel to ensure there is propane in
your tank. See section entitled "Liquid Propane Gas
System" for details.
6. If there is propane in the tank and the burner fails to
ignite, verify that the LP gas valve switch is in the "ON"
position.
7. If the furnace still fails to light, turn the thermostat to
the off position, turn the LP gas valve switch "OFF"
and contact your dealer or a local RV service center.
IMPORTANT
After the initial start up, the furnace will automatically
cycle on and off as it delivers the required heat.
Warning
Always set the thermostat fan to "AUTO" mode before
turning on heat.
1-36
Serenity / Libero Motorhome
1
2