Remote Control - Friedrich UE10C33 Service And Parts Manual

REMOTE CONTROL

POWER
To turn the air conditioner ON,push this button.
To turn the air conditioner OFF,push the button again.
This button takes priority over any other button.
TEMPERATURE SETTING
Use this button to automatically control the temperature of the room.
The tmeperature can be set within a range of
increments of 1 F.
The setting appears in the display.
FAN SPEED
Every time you push this button,it advances the setting as follows:
{High[F2] Low[F1]} High[F2]
TIMER
SHUT-OFF TIME
You will usually use shut-off time while you sleep.
If unit is running,use Timer to set number of hours until shut-off.
For your sleeping comfort once Timer is set the Temperature setting will
raise 2 F after 30 min and once again after another 30 min.
Push Timer button to advance setting from 1Hour→ 2Hour →...
→12Hours maximum.
START TIME
If unit is off,use Timer to set number of hours before nuit starts.
Push Timer button to advance setting from 1Hour→ 2Hour →...
→12Hours maximum.
MODE
Push this button to shift mode of operation from COOL → MONEY SAVER→ FAN ONLY→HEAT
COOL:
Fan runs continually for normal cooling operation.
MONEY SAVER:
The fan stops when the compressor stops cooling.Approximately every 3 minutes the fan will turn on and the nuit will
check the room air temperature to determine if cooling is needed.
FAN ONLY:
Fan-only operation.
HEAT:
Fan runs continually for normal heating operation.
CAUTION
When the air conditioner has been performed its
cooling or feating operation and is turned off or
set to the fan position wait at 3 minutes
before resetting to the cooling operation again.
www.sylvane.com 1-800-934-9194
60 F to 86 F by
A slight heat odor may come from the nuit
when first switching to HEAT after the
cooling season is over.This odor,caused
by fine duct particles on the heater,will
disappear quickly.This is harmless.
Service Manual 8