Homelite Trimlite UT20004 Operator's Manual page 15

OPERATION
STARTING AND STOPPING
STARTING
See Figure 12 - 13.
INSTRUCTION
TO START A COLD ENGINE:
LABEL
DO NOT squeeze the throttle trigger until the engine starts
and runs.
STOP
n Lay the trimmer on a flat, bare surface.
BUTTON
n PRIME - Press the primer bulb 7 times.
n SET the start lever to the START position.
n PULL the rope until the engine starts.
n Allow the engine to run for 15 seconds.
n Squeeze the throttle trigger.
NOTE: Squeezing the throttle trigger releases the start lever
PRIMER BULB
to the RUN position.
TO START A WARM ENGINE:
PULL the rope until the engine starts.
THROTTLE
TO STOP THE ENGINE:
TRIGGER
Push and hold the STOP button until the engine stops.
Fig. 12
START LEVER
START
POSITION
START LEVER
RUN
POSITION
Fig. 13
Page 15