Assembly; Front Handle - Homelite Trimlite UT20004 Operator's Manual

If your unit has been preassembled, check each step to make
sure the unit has been properly assembled.

FRONT HANDLE

See Figure 2.
n Remove the front handle, bolt, and wing nut from the
Owner's Kit.
n Install the front handle onto the top side of the drive shaft
housing and move it to a comfortable position.
n Place the bolt through the front handle as shown, then
install the wing nut.
n Tighten wing nut securely.
CURVED SHAFT GRASS DEFLECTOR
WITHOUT EDGER GUIDE - TRIMLITE AND
TRIM 'N EDGE
See Figure 3.
n Remove wing nut, flat washer, lock washer, and bolt from
the Owner's Kit.
n Place curved shaft grass deflector over shaft and brack-
et.
n Install bolt through the slots in the tabs on grass deflector
and bracket on shaft housing.
n Install flat washer, lock washer and wing nut.
n Tighten Securely.
CURVED SHAFT GRASS DEFLECTOR WITH
EDGER GUIDE - TRIM 'N EDGE ONLY
EDGER GUIDE ASSEMBLY
See Figure 4.
n Assemble the two plastic pieces of the edger guide together
using the short bolt, flat washer, lock washer and wing
nut.
n Slide the edger guide to adjust it to the desired trimming
length.
n Tighten the wing nut securely.

ASSEMBLY

FRONT HANDLE
WING NUT
BOLT
BRACKET
EDGER GUIDE
PIECES
Page 10
BOLT
GRASS
DEFLECTOR
LOCK WASHER
FLAT
WASHER
WING NUT
WING NUT
LOCK
WASHER
FLAT WASHER
SHORT BOLT
Fig. 2
Fig. 3
Fig. 4