Advertisement
DOOR REPLACEMENT
AND ADJUSTMENT
DOOR
REPLACEMENT
1. Disconnect
oven
from
power
supply
and remove
outer case.
2. Remove two (2) screws holding
lower oven hinge.
3. Remove the oven hinge from the door.
4. Remove door assembly from upper oven hinge.
5. On re-installing
door, insert the upper oven hinge
into the door hinge pin.
6. Insert the lower oven hinge into the door hinge pin.
Then
while
holding
the door
in place secure the
lower oven hinge firmly with the two (2) mounting
screws.
7. Make sure door is parallel
with
ven face lines (left
and upper side lines) and the door latch heads pass
through
the latch holes correctly.
Note: After any service to the door;
(A)
Make sure that the upper
latch switch,
and
lower
latch
switch
switches
are operating
properly.
(Refer to chapter "Test Procedures".).
(B)
An approved
microwave
survey meter should
be used to assure
compliance
with
proper
microwave
radiation
emission
limitation
standards.
DOOR
ADJUSTMENT
The door can be adjusted
by keeping
the screws
of
each hinge loose.
After
adjustment,
make sure of the following
:
1. Door latch heads smoothly
catch,
the latch
hooks
through
the latch
holes,
and also the latch
head
goes through
the center of the latch hole.
2. Deviation
of the door alignment
from horizontal
line
of cavity face plate is to be less than 1 .Omm.
3. The door is positioned
with
its face depressed
to-
ward the cavity face plate.
4. Re-install
outer
case
and
check
for
microwave
leakage around
the door with
an approved
micro-
wave survey meter.
(Refer to Microwave
Measurement
Procedure.)
Note: The door on a microwave
oven
is designed
to
act as an electronic
seal preventing
the leakage
of microwave
energy from the oven cavity during
the cook cycle.
This function
does not require
that
the
door
be
air-tight,
moisture
(condensation)-tight
or
light-tight.
Therefore,
the occasional
apperance
of moisture,
light
or
the sensing of gentle warm air movement
around
the oven
door
is not abnormal
and do not of
themselves,
indicate
a leakage of microwave
en-
ergy from the oven cavity.
If such were the case,
your oven could
not be equipped
with
a vent,
the very
purpose
of which
is to exhaust
the
vapor-laden
air from the oven cavity.
LATCH
HEADS
\
DOOR
LEVER
Figure
C-2.
Door Replacement
and Adjustment
25
Advertisement
