Sound Authoring - E-Mu Vintage Keys Operation Manual

Sound
Authoring
Copy User Bank
to Flash
_ _ _ _
If there is no Flash SIMM
in the unit, the error message,
"Requires Flash SIMM" will be
displayed.
192 E-MU Systems
This is a special purpose function to be used with the Flash sound
authoring feature. Flash Sound SIMMs created on an EOS Ultra sampler can
be used as a custom Vintage Keys bank. Presets are then created in a User
bank. When the bank of presets is finished, it can be copied, using this
function, to the Flash SIMM. Flash SIMMs contain two separate memory
locations. One of these memories contains the sound samples and the
other memory can hold four banks of 128 presets.
For instructions on how to remove and replace ROM SIMMs,
please see "Installing Sound SIMMs" on page 229
The four sound SIMM sockets in Vintage Keys are marked 0-3. The desti-
nation Flash SIMM must be placed in SIMM socket 1.
COPY USER BANK TO FLASH
From: User
To Copy a User Bank to Flash:
Make sure a Flash SIMM is inserted into the extra Vintage Keys SIMM
1.
socket.
Press the Save/Copy menu button.
2.
Rotate the data entry control to select the "Copy User Bank" function
3.
shown above.
Move the cursor to the "From" field and select the User bank that you
4.
want to copy to the Flash SIMM.
Move the cursor to the "To" field and select the Flash bank that you
5.
want to contain the User bank.
Press Enter. The Enter LED will flash and the screen below appears.
6.
Press ENTER to Overwrite
Flash SIMM Presets
Press Enter again to confirm. The following screen appears:
7.
COPYING USER BANK TO FLASH
Done. Please Reboot Now.
The Flash presets cannot be used until Vintage Keys is rebooted (power
8.
off then on). Reboot the Vintage Keys and verify that the new Flash
bank has been properly copied.
0
To: Flash
Save/Copy Menu
Copy Preset Bank
.
2