Bosch D9412GV4 Owner's Manual page 71

Control Panels
To test individual detection devices, simply activate
sensors and open protected doors and windows one-at-
a-time. As you fault each detection device, the keypad
from which you initiated the test emits a brief tone, and
for 60 seconds the display indicates that the point was
tested. The tone and display verify that each detection
device is working properly. Keypads within the area's
scope from which you did not initiate the walk test
show Walk test in progress during the testing.
Performing a walk test:
1. Open the Main menu.
2. Press [Actions] to open the menu.
3. Press [Test] to open the menu.
4. Press [Walk Test] to open the menu.
5. Press [Fire] , [Intrusion], [Service], or [Invisible]
based upon the type of walk test you wish to
perform.
6. The keypad shows the number of points remaining
to test. Press [View Untested Points].
7. Use
and view the status of that point.
8. Escape from the menu.
Automatic termination
The Walk Test automatically ends after 20 minutes of no
test activity. The keypad sounds during the last 5
minutes of the test.
Bosch Security Systems, Inc.
/[NEXT] to go through your desired point
B94x/B93x Actions menu | en
2014.04 | 05 | F.01U.287.176
71