Table of Contents
Advertisement
CONTENTS
1) Before Starting
26
2) Package Contents
26
3) General Cautions
26
4) Cautions on Installation
27
5) Installing the Source Unit
27
6) Removing the Source Unit
29
7) Wiring and Connections
30
8) Connecting the accessories
31
1) Before Starting
1. This set is exclusively for use in cars with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery "terminal" beforE
starting. This is to prevent short circuits during
installation. (Figure 1)
Car battery
2) Package Contents
Figure 1
Source unit
1
Front panel
1
Trim ring
1
Mounting bracket
1
Screws M5x6 mm
4
L-key
2
3) General Cautions
1. Do not open the case. There are no
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
26
CZ301
Wire connector
1
Remote control unit (with battery)
1
DCP case
1
Owner's manual.
1
Warranty card
1
Special screw (Front panel lock)
1
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol etc. For tough dirt,
apply a little cold or warm water to a
soft cloth and wipe off the dirt gently.
Advertisement
Table of Contents
