Table of Contents
Advertisement
Satellite Radio Mode
Listeners can subscribe to SIRIUS® Radio
on the Web by visiting www.sirius.com. or
by calling (888) 539-SIRIUS. Customers
should have their SIRIUS 10 ready (SIRIUS
10 is located on the SCC1: SIRIUS Connect
Vehicle Tuner, solid separately). Customers
can listen to music samples by tuning to
channel 184.
Accessing satellite radio mode
Press the [SRC
I
<9 ]
button on the front
panel or remote control to switch to the SAT
source.
Displaying the Identification
(10)
Code
Before you listen to satellite radio, you must
subscribe to the service using your radio's
identification number. To display the radio
10, use the
[~]
tuning button to tune to
channel "0". The screen displays the radio 10
where the channel name is usually displayed.
Check SC-C1 SIRIUS Connect
Vehicle TUNER
If SIRIUS tuner is not connected, "NO
TUNER" will appear on the LCD.
Select
a
band
Press the [BAND] button to change between
three SAT bands (SR1, SR2 and SR3). Each
band stores up to six preset stations.
Select
a
station
Press the [
~
] or [
~
] tuning button to
tune to another station.
Preset mode
Six numbered preset buttons store and recall
stations for each band.
Preset scan
Short press the [PS/AS] button to start
category scanning.
Long press [PS/AS] (1 sec.) to start preset
station scanning for 10 seconds each.
Storing a station
1. Select a band (if needed), then select a
station.
2. Press and hold a preset button (numbers
1-6) on the front panel.
3. The preset number and station is
displayed and highlighted.
Recalling
a
station
1. Select a band (if needed).
2. Press a front panel preset button
(numbers 1-6) to select the corresponding
stored station.
Category and Channel search
To access Category and Channel Search
mode, press the [BAND] button more than 1
second on the front panel.
1. Rotate the [VOLUME] knob on the panel
to select the desired category.
2. Press the [
~
] or [
~
] button to select
the channel name.
Direct search
To access Direct Search mode, press the
[MENU] button on the front panel.
1. Rotate the [VOLUME] knob on the panel
to select the desired direct, and press the
knob to confirm the selection.
2. Rotate the [VOLUME] knob on the panel
to select the direct number, and press the
knob to confirm the selection.
PASSWORD
Refer to System Setup page 11.
14
CZ301
Advertisement
Table of Contents
